Author Topic: Question about front and back wall slots  (Read 467 times)

Offline Milos Gulan

  • Hero Member
  • *****
  • Posts: 3132
Question about front and back wall slots
« on: December 06, 2013, 04:17:19 AM »
Is it possible to have 2 slots for one wall, to see front side differently and back side too like it is shown here for that prison window http://ua.reonis.com/index.php?topic=2543.0

I was curious for example when i want to make front of the house look differntly then inside.

If yes how can i achieve it.

Offline Dinonykos

  • Dungeon Craft Tester
  • Hero Member
  • ***
  • Posts: 2332
    • Dinonykos Dungeon Craft
Re: Question about front and back wall slots
« Reply #1 on: December 06, 2013, 05:42:13 AM »
In the editor, there are two options to achieve what you desire.

1)
Mode: Editor options: deactivate "Place wall on both sides of map cell boundary" - you can then place the walls as you probably are used to by clicking into the map cells.

2)
Use the buttons below the 3d-view to place the walls. The walls should only be placed on the side you see.

Find four contributions to the Pre-Generated Character Mini-Module Design Contest on my homepage.
New: THE AMBASSADOR'S LETTER, my contribution to the 7-day-challenge.
DINONYKOS DUNGEON CRAFT DESIGN HOMEPAGE

Offline Milos Gulan

  • Hero Member
  • *****
  • Posts: 3132
Re: Question about front and back wall slots
« Reply #2 on: December 06, 2013, 05:59:25 AM »
Wow :) it works greatly. Thanks so much for this. Now i will be able to work a lot better.

 

anything